ideaFormer | LutraCAD Documentation

📄️Installation

Here you can find an explaination on how to set up your printer.

Here you can find the instructions how to clean the Nozzle of your Belt printer, follow along step by step.

This is a step-by-step guide on how to change your Nozzle.

Here you can find the instructions how to Load the Filament on your Belt printer.

Here you can find the instructions how to Unload the Filament on your Belt printer, follow along step by step!

Here you can find the instructions how to Calibrate the Scraper on your Belt printer, follow along step by step!

Here you can find the instructions how to Center the Belt on your Belt printer.

These are the parts that you can grease.

Go to Configure (left bottom) and click Bed Mesh. This will show a picture like below.

If the printhead is too close, increase the Y-Offset.

1. Go to configuration.

Maintenance Information

Printer error messages