Installation
This guide explains how to set up your IdeaFormer belt printer and connect it to LutraCAD.
Clean Nozzle
Here you can find the instructions how to clean the Nozzle of your Belt printer, follow along step by step.
Replace Nozzle
This is a step-by-step guide on how to change your Nozzle.
Load Filament
Here you can find the instructions how to Load the Filament on your Belt printer.
Unload Filament
Here you can find the instructions how to Unload the Filament on your Belt printer, follow along step by step!
Calibrate Scraper
Here you can find the instructions how to Calibrate the Scraper on your Belt printer, follow along step by step!
Center Belt
Here you can find the instructions how to Center the Belt on your Belt printer.
Grease Sliders
Here you can find the instructions how to grease the sliders on your Belt printer.
X-Axis Calibration
This guide explains how to check and calibrate the bed mesh on your Belt printer so the belt is level from left to right.
Y-Offset
The Y-Offset sets the distance between the printhead and the belt. If the printhead is too close, increase the Y-Offset. If the printhead is too far away, lower the Y-Offset.
Connect to Wi-Fi
This guide explains how to connect your Belt printer to a Wi-Fi network and find its IP address.
Maintenance
This page lists the recommended maintenance tasks for your Belt printer and how often to perform each one.
Printer error messages
This page lists common error messages on your Belt printer and how to resolve them.